VoIP Gateway - h323 SIP FXO WellGate 3802A/3804A

VoIP Gateway - h323 SIP FXO WellGate 3802A/3804A

Introduction

WellGate 3802A/3804A is a two/four-FXO-port Gateway, which represents
an interface to access PSTN and provides voice and fax over IP services.
By connecting with ADSL or cable Modem, WellGate 3802A/3804A provides
saving in network infrastructure and greatly reduced telephone charges.
With H.323 v2/v3/v4 or SIP protocol, Welltech create ideal solution for
providing low cost communications between headquarters and branch
offices in the world, as well as for SOHO and office telephony applications


Voice Quality :

- G.168/165-compliant adaptive echo cancellation
-Dynamic Jitter Buffer

Comments

  1. virtual call center solutionsOctober 15, 2012 at 12:44 PM

    I wonder why I did not knew this before.... it was a good read. You are working on a very good blog.. I look forward to visit your blog again....

    ReplyDelete
  2. HGH Human Growth HormoneSeptember 13, 2013 at 12:45 PM

    Great article, very helpful

    ReplyDelete

Post a Comment

Popular posts from this blog

Asterisk - Intermittent beep with linksys SPA 3102, PAP2, DTMF sounds heard during conversation

Image
Asterisk - Intermittent beep with linksys SPA 3102, PAP2, DTMF sounds heard during conversation Asterisk - Intermittent beep with linksys SPA 3102, PAP2, DTMF sounds heard during conversation We had users reporting hearing DTMF sounds during a conversation. We have solved the problem by switching DTMF mode to INBAND in the SPA 3102 config, in the PAP2 config and into Asterisk/FreePBX configuration. 1) In your SPA-3102 html interface, go to /admin/voice/advanced, Line 1 and PSTN Line and set DTMF Tx Method: INBAND in both places. 2) Since we have an asterisk extension mapped to the SPA-3102 Line1, we also went into FreePBX and set the dtmfmode to: "inband" for that extension. (was previously set to SIP-INFO) 3) We also have a SIP trunk in asterisk mapped to the SPA-3102 PSTN line. We went into FreePBX under "Trunks" and set the DTMF mode for that SIP trunk by adding "dtmfmode=inband" in both "Incoming Sett...
Read more